Solar panels and accumulators optimal ratio.
Solar panel accumulator ratio factorio.
Its maximum charge discharge rate is 300 kw.
The optimal ratio is 0 84 21 25 accumulators per solar panel and 23 8 solar panels per megawatt required by your factory this ratio accounts for solar panels needed to charge the accumulators.
The b accumulator b stores a limited amount of energy when available production exceeds demand and releases it in the opposite case.
You see with solar there is some initial investment but after that power is simply free.
Every other power source requires a constant influx of resources to produce power.
The accumulator can store up to 5 mj of energy.
The ratios posted result in more solar panels then are needed to power factory and charge accumulators i had posted this in a topic on the steam forum a week ago when somebody was asking about solar panels and another person brought up the 0 8 1 ratio.
The ratio 100 solar panels to 84 accumulators is optimized for solar panels first than for accumulators.
This means that you need 1 428 mw of production of solar panels and 100mj of storage to provide 1 mw of power over one day night cycle.
We could do that the other way around.
Anyway here s the source.
The ratio doesn t matter nearly as much as people seem to think it does.
While the sun is out your solar panels have to output q power where q p.
I had found that a ratio of 1 2 to 1 5 accumulators per solar panel worked out perfectly fine.
A single solar panel outputs an average of 42 kw over a day and requires 0 84 accumulators to sustain a constant power output through the night.
In the perfect ratio it gives you 42kw per solar cell for 0 resources amortized over time.
Then when both of those are met build some more.
Reverse operation ratio from decimal needs multiplication and reduction by the largest common divisor.
We would need the fewest accumulators if we would just draw power from them if solar panels would produce no power at all.
Solar is the ultimate in resource to power ratio.
Solar panels are producing 0 nominal power 10 of the day.
If connected to a circuit network an accumulator will output its level of charge as an integer from 0 to 100 to a specified signal.
Just divide if you need a decimal.
A single solar panel outputs an average of 42 kw over a day and requires 0 84 accumulators to sustain a constant power output through the night.
Your solar panels have 2 functions.
Dusk dawn so on average they produce 70 of nominal power.
If they don t last the night build more batteries.
If your batteries can t fully charge during the day build more solar.
Provide power p recharge accumulators.
Now you have enough for a while.
